Veteran & Fireman Owned · Land clearing, forestry mulching & grading · Greensboro, NC & the Piedmont TriadCall or text (336) 392-8138
Land & Lot Clearing · Guilford / Randolph County · 25 min from Greensboro

Brush Clearing for Julian & Guilford / Randolph County

Briars, saplings, honeysuckle and privet — mulched flat in a single pass.

Brush clearing in Julian is the job you do before it becomes a land clearing job. The saplings are still small, the briars still mulch clean, and the price is a fraction of what it will be once the pines reach eight inches. We'll show you where your property is on that curve during a free walk-through.

A fair amount of the brush in Julian is growing over something — a downed fence, an old equipment pile, a forgotten drainage ditch. We find it as we go and tell you about it, and if the ditch needs cleaning or the wire needs pulling, the machine's already there.

Rear view of the Kubota SVL97-2 pushing into a thicket with the mulcher head lowered
Working from the outside in on a privet and briar thicket
Kubota SVL97-2 track loader with Fecon forestry mulcher head working through brush and saplings in a Piedmont hardwood stand
Fecon mulcher head on the SVL97 — one pass takes brush and saplings to chips
Forestry mulcher threading between mature oak trunks while clearing understory
Selective clearing — keeper hardwoods stay, everything under them goes

Julian ground conditions and how they shape brush clearing

Jurisdiction matters out here because the county line runs through town; Guilford and Randolph have different erosion control processes, and we check which side a parcel falls on before we start. The slate-belt ground is kind to equipment — it carries a machine in weather that would stop us up north — but it needs seed and cover the same week it's graded. The Alamance Creek bottoms are the exception; we don't push grading down there until summer. Rock near the surface on the ridges can make trenching slow going.

Around Julian Road, Julian Airport and Big Alamance Creek, the properties we're usually called to look like this:

  • Creek-bottom fields along Big Alamance Creek that need ditching before they'll carry hay equipment
  • Thirty- to one-hundred-acre cattle and tobacco tracts off NC-62 and Julian Road with pasture lost to loblolly and privet
  • Hunting and timber land needing food plot edges, shooting lanes and farm roads

What brush clearing jobs look like around Julian

A typical Julian call for brush clearing looks like this: Creek-bottom fields along Big Alamance Creek that need ditching before they'll carry hay equipment. We've handled that exact situation around Big Alamance Creek and Old Julian Road more times than we can count.

The other common one is Thickets around outbuildings, barns and well heads, which usually means a tighter work area and more care around what stays.

If your property is somewhere in between, send the address and we'll tell you which side of the line it falls on.

Neighbors in Climax, Whitsett and Staley call us for the same work; Julian sits right in the middle of that route.

Why Julian property owners call A&R

If the brush in Julian was hiding a bad fence line, a clogged ditch or a rough spot that needs grading, we handle those while we're on site. One contractor, one trip.

Call or text (336) 392-8138 for a free brush clearing estimate in Julian. We'll walk it with you and tell you exactly what the mulcher will do on your growth.

Brush Clearing in Julian: questions

Can you clear brush around my fence without tearing it up?

Yes. The mulcher runs tight to a fence line and we work the far side by hand or with the rotary cutter where the head won't fit. If the fence is already down inside the brush, we'll find it before we hit it — that's part of the walk-through.

Do you need to burn or haul the brush?

No. The mulcher grinds it into chips that stay on the ground, which means no burn permit, no smoke complaints and no dump trailer loads. If you specifically want the ground bare, we can rake and haul the chips, but most people prefer to leave them.

How far is A&R Land Services from Julian?

We're based in Greensboro, about 25 minutes from Julian. Guilford / Randolph County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.

Do you handle brush clearing near Julian Road and Julian Airport?

Yes. We work throughout Julian and the surrounding Guilford / Randolph County area, including properties around Julian Road, Julian Airport and Big Alamance Creek. If you're outside the town limits, send the address and we'll confirm it's in range.

What does brush clearing typically involve on a Julian property?

Pre-sale cleanup so buyers can walk the property is the most common version of it around Julian. A written price and scope based on the walk. Brush clearing is usually a single-day job, and we tell you up front whether anything on the property is beyond what the mulcher handles in one pass. How clean you want the finish — single pass versus refined mulch layer is the factor that moves the price most on Guilford / Randolph County jobs, and we'll walk through it with you on site.

Brush Clearing in Julian, done right the first time.

Call, text, or send a few photos and the address. Clark walks the property with you and puts a real number on the work.

(336) 392-8138Request an estimate