Rough grading sets the bones of a Apex property. Get it wrong and every trade after you fights it — footings, slabs, drives, the lawn. We're about 1 hour 10 minutes from Apex, and we grade it right the first time so nobody has to come back.
The ground around Apex is rolling Piedmont, so most lots have a high side and a low side and a natural drainage line between them. Rough grading here is usually a matter of cutting the upper side, filling the lower, and making sure the pad sits above the wet end. We read that on the walk-through before any stakes go in.



Apex ground conditions and how they shape rough grading
Apex has been one of the fastest-growing towns in the country for a decade, and the land work follows. Former farms along US-64, NC-55, Old US-1 and Jenks Road are being cleared and rough graded for subdivisions, and builders need lot clearing, stumps and pads in the neighborhoods going in west toward New Hill and south toward Holly Springs. There is also a steady stream of understory mulching on the older estate lots off Olive Chapel Road and Salem Church Road. Out past New Hill toward the Chatham line it's still five- to twenty-acre tracts with pasture to reclaim and Jordan Lake frontage.
Around Jordan Lake, US-64 and Jenks Road, the properties we're usually called to look like this:
- Former farms along US-64, NC-55 and Jenks Road being cleared and rough graded for subdivisions
- Older estate lots off Olive Chapel Road and Salem Church Road wanting understory mulched and vines removed
- Five- to twenty-acre tracts past New Hill toward the Chatham line with pasture to reclaim and Jordan Lake frontage
What rough grading jobs look like around Apex
If you're near Jenks Road or Salem Church Road, odds are your situation is one we've already worked: former farms along US-64, NC-55 and Jenks Road being cleared and rough graded for subdivisions, or sloped yards being terraced or opened up for use.
The rough grading approach for Wake County ground is the same either way — look first, quote in writing, bring the right attachment, walk it with you when it's done.
Raleigh, Sanford and Pittsboro are in the same loop as Apex for us — same crew, same pricing basis.
Why Apex property owners call A&R
Laser-checked elevations on every Wake County rough grade. Builders in Apex appreciate handing a site to their foundation crew that's where the plan says it is, not somewhere in the neighborhood.
Send us your site plan and the address of the Apex lot. We'll come walk it and give you a written price for the dirt work.
Rough Grading in Apex: questions
What's the difference between rough grading and final grading?
Rough grading moves the volume and gets the site within a few inches of its planned shape — cuts, fills, drainage pattern, pad location. Final grading is the last step after construction: smoothing, setting the exact slope, spreading topsoil and leaving it ready for seed or sod. Most new builds need rough grading before the foundation and final grading after the framers and trades are gone.
Do I need a grading permit in North Carolina?
Disturbing more than an acre requires an approved sediment and erosion control plan under state rules, administered by the county or the state depending on where you are. Under an acre, most counties don't require a grading permit, though cities like Greensboro and Winston-Salem have stormwater and buffer rules that can apply. We'll point you to the right office if your lot is near the line.
How far is A&R Land Services from Apex?
We're based in Greensboro, about 1 hour 10 minutes from Apex. Wake County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle rough grading near Jordan Lake and US-64?
Yes. We work throughout Apex and the surrounding Wake County area, including properties around Jordan Lake, US-64 and Jenks Road. If you're outside the town limits, send the address and we'll confirm it's in range.
How do you approach rough grading on Apex ground?
New home sites after clearing, before footings go in is the most common version of it around Apex. Fill placed in six-to-eight-inch layers and tracked in as it goes. Pads and anything taking a load get the most attention here. Laser checks throughout. Depth of cuts and whether rock or roots are in the way is the factor that moves the price most on Wake County jobs, and we'll walk through it with you on site.