A&R Land Services installs culverts and driveway pipe in Reidsville — state road entrances, private drives, farm lanes and ditch crossings. We're only about 30 minutes from Reidsville, which keeps the mobilization cost down on what's usually a one-day job.
Most of the Reidsville culvert jobs we do are on state-maintained secondary roads, where NCDOT sets the minimum pipe size and length through the driveway permit. We'll tell you what to expect from the district office and we build the entrance to meet it, because an entrance that doesn't pass inspection is one you'll be paying for twice.



Reidsville ground conditions and how they shape culverts
Reidsville ground is mostly Cecil and Wedowee sandy loam over red clay subsoil, with Helena and Enon pockets on the flatter divides that stay greasy for days after a rain. Troublesome Creek and Little Troublesome Creek wrap around the south and west sides of town and feed Lake Reidsville, and the Haw River itself slides past just southwest of the city limits. Nearly every tract we clear here was in tobacco within living memory. Those old fields went fallow when the allotments disappeared, and twenty years later they are a solid stand of Virginia pine and sweetgum with privet and multiflora rose packed in underneath.
Around Lake Hunt, the Haw River and Chinqua-Penn Walking Trail, the properties we're usually called to look like this:
- Vacant mill-village lots inside the city that have been sitting under sweetgum and privet for decades
- Fence lines and ditches along Wolf Island Creek and Troublesome Creek that cattle operations need pushed back and reopened
- Wooded 1–5 acre home sites off US-158 and Vance Street Extension where buyers want a pad, driveway and septic area opened
What culverts jobs look like around Reidsville
A typical Reidsville call for culverts looks like this: Vacant mill-village lots inside the city that have been sitting under sweetgum and privet for decades. We've handled that exact situation around Chinqua-Penn Walking Trail and NC-14 (Freeway Drive) more times than we can count.
The other common one is New driveway entrances on state roads and private roads, which usually means a tighter work area and more care around what stays.
If your property is somewhere in between, send the address and we'll tell you which side of the line it falls on.
Neighbors in Eden, Browns Summit and Greensboro call us for the same work; Reidsville sits right in the middle of that route.
Why Reidsville property owners call A&R
We handle the permit question up front. If your Reidsville driveway is on a state road, we'll tell you what NCDOT is going to require before we quote, so there's no surprise about pipe size or length after the fact.
Send us a photo of the ends of your Reidsville driveway pipe and we'll tell you whether it's crushed, undersized or just silted shut before we schedule the visit.
Culverts in Reidsville: questions
What size culvert do I need for my driveway?
It depends on how much water the ditch carries, which depends on the drainage area above it. 15 inches is a common minimum on quiet roads; 18 and 24 inches are common where the ditch drains a larger area. On state roads NCDOT decides. On private property we size to the drainage area with a margin, because an undersized pipe is the most common reason an entrance washes out.
Can you replace a crushed culvert pipe?
Yes, and it's one of the most common jobs we do. The excavator pulls the old pipe, we clean out the silt, cut the trench to the right grade, set new pipe on stone bedding and rebuild the drive over it. If the old pipe was undersized or set too high, we fix that at the same time.
How far is A&R Land Services from Reidsville?
We're based in Greensboro, about 30 minutes from Reidsville. Rockingham County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle culverts near Lake Hunt and the Haw River?
Yes. We work throughout Reidsville and the surrounding Rockingham County area, including properties around Lake Hunt, the Haw River and Chinqua-Penn Walking Trail. If you're outside the town limits, send the address and we'll confirm it's in range.
What should I expect from a culverts job in Rockingham County?
Entrances that flood or wash out every big storm is the most common version of it around Reidsville. We look at the ditch, estimate the drainage area, check for utilities and figure out whether the road is state-maintained. If it is, we'll walk you through the NCDOT driveway permit and what size pipe they'll require. Permit requirements and distance from Greensboro is the factor that moves the price most on Rockingham County jobs, and we'll walk through it with you on site.