Erosion on Siler City land is a slow emergency — a rill this year, a gully next year, a slope that can't hold grass the year after. A&R Land Services stops that progression across Chatham County with regrading, diversions, riprap and cover, and we're about 50 minutes away in Greensboro.
A lot of Siler City homes sit on lots that were cut into a hillside, with a steep bank in the back that the builder seeded once and never looked at again. Those banks wash a little every year until they're a problem. We regrade them to a slope that holds, divert the water at the top and get real cover established.



Siler City ground conditions and how they shape erosion control
Since the Wolfspeed and VinFast announcements, western Chatham has been under heavy development pressure. The megasite along US-421 at Moncure has pulled contractor yards, worker housing and new subdivisions toward Siler City, and we've picked up a lot of commercial clearing and rough grading on parcels along US-64, US-421 and the Siler City bypass that were chicken-house and cattle land five years ago. The rural work hasn't gone away either — reclaiming overgrown pasture around Bonlee, Bennett and Goldston is steady year-round.
Around US-64, the Rocky River and Loves Creek, the properties we're usually called to look like this:
- Wooded one- to five-acre home lots in new subdivisions off the bypass that need lot clearing and pad prep over shallow rock
- Hunting tracts along the Rocky River and Bear Creek needing trails, food plots and firebreaks
- Former poultry and cattle farms along US-64 and US-421 being graded for contractor yards, storage and new housing
What erosion control jobs look like around Siler City
One job we see over and over near Loves Creek: Wooded one- to five-acre home lots in new subdivisions off the bypass that need lot clearing and pad prep over shallow rock. That's textbook erosion control work, and it's usually a one-mobilization job for us.
Out toward Alston Bridge Road the pattern changes — more Property above a creek that needs to stop sending silt downstream. The approach is the same, the time on site is what moves.
Either way, the first question we ask on a Siler City site walk is what the ground needs to do afterward, because that decides how far we take it.
Seagrove, Staley and Asheboro are in the same loop as Siler City for us — same crew, same pricing basis.
Why Siler City property owners call A&R
Being about 50 minutes from Siler City means we can come look at the slope while it's raining, which tells us more in ten minutes than a dry walk tells us in an hour. It also means a return trip after the first storm is a short drive, not a favor.
For erosion control and slope repair in Siler City, call (336) 392-8138. We've stopped a lot of Chatham County clay from reaching the creek, and we can stop yours.
Erosion Control in Siler City: questions
How do I stop erosion on a slope in red clay?
Three things, in order: keep water from concentrating on the slope by diverting it at the top, reshape the slope so what does run sheets off instead of channeling, and get cover on the clay — seed and straw, mulch or erosion blanket. Clay only erodes when it's bare and water is moving fast. Fix those two conditions and it stops.
Do I need a permit for erosion control work in NC?
For small repairs on your own property, no. North Carolina's Sedimentation Pollution Control Act kicks in when you disturb more than an acre, and that requires an erosion and sediment control plan approved by the state or your county. Work inside a stream buffer has its own rules. We'll tell you if your project crosses either line.
How far is A&R Land Services from Siler City?
We're based in Greensboro, about 50 minutes from Siler City. Chatham County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle erosion control near US-64 and the Rocky River?
Yes. We work throughout Siler City and the surrounding Chatham County area, including properties around US-64, the Rocky River and Loves Creek. If you're outside the town limits, send the address and we'll confirm it's in range.
How do you approach erosion control on Siler City ground?
Gullies cutting through pasture, lawns and wooded lots is the most common version of it around Siler City. We come back after the first heavy rain to make sure the water is going where it's supposed to and touch up anything that moved. Erosion work is only done when it's been tested. Whether the disturbed area triggers a state erosion control plan is the factor that moves the price most on Chatham County jobs, and we'll walk through it with you on site.