Veteran & Fireman Owned · Land clearing, forestry mulching & grading · Greensboro, NC & the Piedmont TriadCall or text (336) 392-8138
Grading · Davidson County · 1 hr from Greensboro

Denton Building Pads

A level, compacted pad your foundation crew can trust.

If you're building in Denton and the lot has been cleared, the pad is the next step. We're about 1 hour away in Greensboro, and we build pads to the builder's finished floor elevation with the fill compacted properly, because loose Davidson County clay is the main reason foundations here move.

Metal building and pole barn pads are a steady part of our Denton work. Those slabs are big and thin, which makes them sensitive to settlement, so the pad under them has to be uniformly compacted edge to edge. We build them with the overbuild the slab crew needs and check them with a laser.

Kubota SVL97-2 track loader with Fecon forestry mulcher head working through brush and saplings in a Piedmont hardwood stand
Fecon mulcher head on the SVL97 — one pass takes brush and saplings to chips
Forestry mulcher threading between mature oak trunks while clearing understory
Selective clearing — keeper hardwoods stay, everything under them goes
Freshly cleared and rough-graded backyard lot with track marks, mature trees left standing beside a house
Backyard lot cleared and rough graded, shade trees kept

Denton ground conditions and how they shape building pads

The two jobs we get most around Denton are lake lots and hunting land. High Rock and Tuckertown lot owners at Healing Springs, Jackson Hill and along NC-47 want a steep, rocky bank thinned out so they can get to the water and see it from the house. Hunting clubs and families on the big timber tracts toward Handy, Silver Hill and the Montgomery County line need lanes cut, plots opened, and old logging roads graded so a truck can get in. The farms that are left on NC-109 and NC-49 call for pasture reclamation and poultry house pads, and Denton FarmPark-area properties want fence rows cleaned up.

Around NC-49, NC-47 and Denton FarmPark, the properties we're usually called to look like this:

  • High Rock and Tuckertown lake lots at Healing Springs, Jackson Hill and along NC-47 with steep, rocky banks to thin for access and a view
  • Fence rows and pond banks around Denton FarmPark-area farms grown up in cedar and privet
  • Remaining farms on NC-109 and NC-49 needing pasture reclaimed from pine and poultry house pads cut

What building pads jobs look like around Denton

A typical Denton call for building pads looks like this: High Rock and Tuckertown lake lots at Healing Springs, Jackson Hill and along NC-47 with steep, rocky banks to thin for access and a view. We've handled that exact situation around Denton FarmPark and Healing Springs more times than we can count.

The other common one is Sloped lots that need a cut-and-fill pad to hold a level floor, which usually means a tighter work area and more care around what stays.

If your property is somewhere in between, send the address and we'll tell you which side of the line it falls on.

Albemarle, Thomasville and Seagrove are in the same loop as Denton for us — same crew, same pricing basis.

Why Denton property owners call A&R

We'll tell you up front whether your Denton pad needs engineered fill and geotech testing. We're not a general contractor or an engineer; we're the dirt crew, and we'd rather set you up right than have you find out later.

A&R Land Services is about 1 hour from Denton. Reach out and we'll get your Davidson County pad built before the footings are due.

Building Pads in Denton: questions

Do you need a permit to build a pad?

The pad itself usually falls under your building permit, which the builder or the owner pulls through the county inspections office. If the total disturbed area on the lot goes over an acre, a state sediment and erosion control plan is required too. We'll help you figure out which applies before we start.

How high should a building pad be above grade?

High enough that water runs off it in every direction. A few inches above surrounding grade with a slight crown is typical for a crawl space home; a slab pad gets set a specific depth below finished floor so the stone and concrete land at the right height. Your builder's finished floor elevation is the number we grade to.

How far is A&R Land Services from Denton?

We're based in Greensboro, about 1 hour from Denton. Davidson County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.

Do you handle building pads near NC-49 and NC-47?

Yes. We work throughout Denton and the surrounding Davidson County area, including properties around NC-49, NC-47 and Denton FarmPark. If you're outside the town limits, send the address and we'll confirm it's in range.

How do you approach building pads on Denton ground?

New home sites on crawl space, slab or basement foundations is the most common version of it around Denton. We review the site plan, stake the footprint with working room around it, set a laser benchmark to the finished floor elevation, and work out cut and fill. Access for equipment and trucks is the factor that moves the price most on Davidson County jobs, and we'll walk through it with you on site.

Building Pads in Denton, done right the first time.

Call, text, or send a few photos and the address. Clark walks the property with you and puts a real number on the work.

(336) 392-8138Request an estimate