If you've bought land in Graham and you're planning a home, shop or barn, the first contractor on site should be the dirt crew. A&R Land Services is about 30 minutes from Graham, and we turn raw ground into a build-ready lot.
Most of the lots we prep around Graham are wooded, sloped and sitting on clay with a few inches of topsoil over it. That shapes the sequence: mulch and clear, save the topsoil, cut the pad into the high side, and shape every drainage path before the first truck arrives.



Graham ground conditions and how they shape site prep
Graham is the Alamance County seat and sits just south of Burlington on the same tough ground — Enon, Iredell and Mecklenburg clays over diabase, with Cecil on the higher ridges. The Haw River runs along the east side of town with Big Alamance Creek and Back Creek feeding in, and the bottoms along them are Chewacla silt that floods. Graham-Mebane Lake on Back Creek is the town's water supply. Old fields come back as loblolly, red cedar and sweetgum, with privet, honeysuckle and Bradford pear filling in along the roads.
Around Back Creek, NC-87 and Haw River, the properties we're usually called to look like this:
- Flat Iredell clay fields that need ditching and swales before they'll carry hay equipment
- Twenty- to eighty-acre cattle and hay farms off NC-87, NC-49 and Swepsonville Road reclaiming pasture from cedar and privet
- Haw River frontage near Swepsonville with overgrown banks and trails to cut
What site prep jobs look like around Graham
Most of our site prep work in Graham comes from two directions. First, flat Iredell clay fields that need ditching and swales before they'll carry hay equipment. Second, infill lots in town that need clearing and grading before permits.
Both show up regularly along Haw River and Big Alamance Creek, and both are jobs we can usually walk, quote and schedule inside a couple of weeks.
Neighbors in Elon, Saxapahaw and Haw River call us for the same work; Graham sits right in the middle of that route.
Why Graham property owners call A&R
One contractor for the whole sequence in Alamance County — clearing, stumps, grading, pad, drive, drainage. Builders in Graham like getting one estimate and one phone number instead of coordinating four crews.
Send us the address and plans for your Graham lot. We'll come look, sequence the work, and put a written number on it.
Site Prep in Graham: questions
How long does site prep take?
An open lot with a pad and a short drive can be done in two or three days. A wooded lot with heavy clearing, stumps, a long driveway and a sloped pad can run a week or more, and wet weather adds to that because clay can't be graded or compacted when it's saturated. We give a realistic schedule in the estimate and keep your builder informed.
Where do you do site prep?
Greensboro and the Triad, plus about an hour and twenty minutes out — Reidsville and Eden up to the Virginia line, Mount Airy and Elkin to the west, Salisbury, Albemarle and Sanford to the south, and Durham, Chapel Hill and Raleigh to the east.
How far is A&R Land Services from Graham?
We're based in Greensboro, about 30 minutes from Graham. Alamance County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle site prep near Back Creek and NC-87?
Yes. We work throughout Graham and the surrounding Alamance County area, including properties around Back Creek, NC-87 and Haw River. If you're outside the town limits, send the address and we'll confirm it's in range.
What should I expect from a site prep job in Alamance County?
Lots where a previous site prep was left half-done is the most common version of it around Graham. Mulch the brush, fell and handle the big timber, pull stumps from the pad, drive and septic areas. Mulch stays where nothing is being built. Length and base depth of the driveway and stone delivered is the factor that moves the price most on Alamance County jobs, and we'll walk through it with you on site.