Veteran & Fireman Owned · Land clearing, forestry mulching & grading · Greensboro, NC & the Piedmont TriadCall or text (336) 392-8138
Forestry Mulching & Land Management · Guilford County · 15 min from Greensboro

Trail Cutting for Jamestown & Guilford County

Walking trails, ATV paths and equipment access cut through the woods and left mulched.

Wooded land in Jamestown is a lot more fun with a trail through it. A&R Land Services cuts walking loops, UTV paths and equipment lanes across Guilford County with a forestry mulcher, leaving a chip floor you can ride the same day. We're about 15 minutes away in Greensboro.

Nearly every trail we cut in Guilford County crosses a creek or a wet-weather branch. On Jamestown properties we place the crossing where the bottom's firm, keep the clearing narrow inside the buffer, and set stone or a culvert if you'll be driving it in the wet.

Trail entrance cut from a gravel drive into the woods with brush mulched back
Trail opened off the gravel drive
Kubota SVL97-2 track loader with Fecon forestry mulcher head working through brush and saplings in a Piedmont hardwood stand
Fecon mulcher head on the SVL97 — one pass takes brush and saplings to chips
Forestry mulcher threading between mature oak trunks while clearing understory
Selective clearing — keeper hardwoods stay, everything under them goes

Jamestown ground conditions and how they shape trail cutting

Drainage comes up on nearly every Jamestown job. The town slopes toward the Deep River and High Point Lake, and the low side of most lots has standing water in winter. We've put in a good number of French drains and short ditch runs here, and we talk to owners about where mulched material should and shouldn't sit when the lot drains into the lake watershed. Summer and early fall are the easy months to grade. Winter work gets planned around a few dry days.

Around Dillon Road, Mendenhall Homeplace and Vickrey Chapel Road, the properties we're usually called to look like this:

  • Older homeplaces near Mendenhall and Castle McCulloch with wisteria-covered outbuildings and overgrown fence rows
  • Infill lots between established subdivisions that need clearing and a level pad before a builder will commit
  • Wooded strips along the Deep River and the Bicentennial Greenway that owners want thinned without clear-cutting the buffer

What trail cutting jobs look like around Jamestown

A typical Jamestown call for trail cutting looks like this: Older homeplaces near Mendenhall and Castle McCulloch with wisteria-covered outbuildings and overgrown fence rows. We've handled that exact situation around Vickrey Chapel Road and Penny Road more times than we can count.

The other common one is Walking and running loops on wooded homesites, which usually means a tighter work area and more care around what stays.

If your property is somewhere in between, send the address and we'll tell you which side of the line it falls on.

We also cover trail cutting in Archdale, Pleasant Garden and High Point, so if you've got property in more than one spot we can often batch the work.

Why Jamestown property owners call A&R

Greensboro to Jamestown is about 15 minutes, which keeps a half-day trail job worth doing and makes it easy to come back and add a loop or a spur later.

Send us an aerial with the route sketched in and a couple of photos of the woods. We'll give you a real number for cutting it in Jamestown.

Trail Cutting in Jamestown: questions

Will the trail turn into mud?

Not if it's routed right. A trail that runs straight down a slope on Piedmont clay becomes a gully; one that follows the contour and crosses slopes at an angle sheds water. We route for drainage, keep the mulch layer on the path, and put gravel on any stretch that's going to be wet no matter what — usually creek approaches and the bottom of climbs.

Can you cut a trail across a creek?

Yes. We pick the crossing where the banks are low and the bottom is firm, keep the clearing narrow inside the buffer, and either set stone for a ford or install a culvert with fill over it, depending on how much water runs and how often you need to cross it in the wet. The excavator and the dump trailer handle it on the same visit.

How far is A&R Land Services from Jamestown?

We're based in Greensboro, about 15 minutes from Jamestown. Guilford County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.

Do you handle trail cutting near Dillon Road and Mendenhall Homeplace?

Yes. We work throughout Jamestown and the surrounding Guilford County area, including properties around Dillon Road, Mendenhall Homeplace and Vickrey Chapel Road. If you're outside the town limits, send the address and we'll confirm it's in range.

What does trail cutting typically involve on a Jamestown property?

Access routes to deer stands, food plots and hunting blinds is the most common version of it around Jamestown. We walk the woods with you, lay out the trail with flagging tape, and adjust it for slope, drainage, keeper trees and creek crossings. If you want a loop, access to a stand or a lane to a field, that shapes the route. Access to the start of the trail from where we can unload is the factor that moves the price most on Guilford County jobs, and we'll walk through it with you on site.

Trail Cutting in Jamestown, done right the first time.

Call, text, or send a few photos and the address. Clark walks the property with you and puts a real number on the work.

(336) 392-8138Request an estimate