We level a lot of yards in Julian that have settled over the years, usually where a stump or a trench was buried when the house went up. We're about 25 minutes away in Greensboro, and fixing that is a one-day job for a box blade, a laser and a trailer of topsoil.
Many Julian homes have a yard that was graded once with a bucket when the house was finished and never touched again. The back half of those lots often drains toward the house without anybody noticing until the crawl space gets damp. A laser check tells the story in five minutes.



Julian ground conditions and how they shape yard leveling
Jurisdiction matters out here because the county line runs through town; Guilford and Randolph have different erosion control processes, and we check which side a parcel falls on before we start. The slate-belt ground is kind to equipment — it carries a machine in weather that would stop us up north — but it needs seed and cover the same week it's graded. The Alamance Creek bottoms are the exception; we don't push grading down there until summer. Rock near the surface on the ridges can make trenching slow going.
Around NC-62, Troxler Mill Road and Stinking Quarter Creek, the properties we're usually called to look like this:
- Thirty- to one-hundred-acre cattle and tobacco tracts off NC-62 and Julian Road with pasture lost to loblolly and privet
- Creek-bottom fields along Big Alamance Creek that need ditching before they'll carry hay equipment
- Horse properties along NC-62 needing fence lines mulched and paddocks leveled
What yard leveling jobs look like around Julian
A typical Julian call for yard leveling looks like this: Thirty- to one-hundred-acre cattle and tobacco tracts off NC-62 and Julian Road with pasture lost to loblolly and privet. We've handled that exact situation around Stinking Quarter Creek and Southeast Guilford area more times than we can count.
The other common one is Lawns with low spots that stay wet for days after rain, which usually means a tighter work area and more care around what stays.
If your property is somewhere in between, send the address and we'll tell you which side of the line it falls on.
Greensboro, Liberty and Staley are in the same loop as Julian for us — same crew, same pricing basis.
Why Julian property owners call A&R
Being about 25 minutes from Julian keeps the mobilization charge small on what's often a half-day job. Yard leveling shouldn't cost a fortune in travel.
A&R Land Services covers Guilford / Randolph County from Greensboro. Reach out and we'll get your Julian lawn regraded.
Yard Leveling in Julian: questions
Should the yard be perfectly flat?
No. A flat yard in our clay is a shallow pond. The target is smooth with a gentle slope — roughly six inches of fall over the first ten feet from the house, then one or two percent across the lawn. That's enough to move water without being noticeable when you mow.
How much does it cost to level a yard?
A single low spot or a side yard that just needs the slope corrected is a half-day job and the least expensive version. Regrading an entire back yard, digging out a settled area and bringing in several loads of topsoil is a full day or two and sits higher. Topsoil is often the biggest single cost, so we'll tell you how many loads it takes. The estimate is free and written.
How far is A&R Land Services from Julian?
We're based in Greensboro, about 25 minutes from Julian. Guilford / Randolph County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle yard leveling near NC-62 and Troxler Mill Road?
Yes. We work throughout Julian and the surrounding Guilford / Randolph County area, including properties around NC-62, Troxler Mill Road and Stinking Quarter Creek. If you're outside the town limits, send the address and we'll confirm it's in range.
What does yard leveling typically involve on a Julian property?
Bumpy, rutted ground that beats up the mower and the operator is the most common version of it around Julian. We look at the low spots, the humps and where the water goes after a rain, probe anything that's actively sinking, and shoot the slope with a laser to see what's really happening. Season and how wet the ground is is the factor that moves the price most on Guilford / Randolph County jobs, and we'll walk through it with you on site.