Veteran & Fireman Owned · Land clearing, forestry mulching & grading · Greensboro, NC & the Piedmont TriadCall or text (336) 392-8138
Grading · Guilford County · 15 min from Greensboro

Land Grading in McLeansville, NC

Water goes where it should, dirt stays where you put it, and the ground is ready for what's next.

Most grading calls we get from McLeansville start with a puddle. Water against a foundation, a soft spot in the yard, a drive that washes every storm. We're about 15 minutes away in Greensboro, and fixing that kind of thing is a one-visit job for a track loader with a box blade and a laser.

Around McLeansville we see a lot of grading that was done once by a builder with a bucket and never touched again. Settling over the years turns that into low spots against the crawl space. A box blade pass with the right slope and a load of fill fixes most of them in a day.

Kubota SVL97-2 track loader with Fecon forestry mulcher head working through brush and saplings in a Piedmont hardwood stand
Fecon mulcher head on the SVL97 — one pass takes brush and saplings to chips
Forestry mulcher threading between mature oak trunks while clearing understory
Selective clearing — keeper hardwoods stay, everything under them goes
Freshly cleared and rough-graded backyard lot with track marks, mature trees left standing beside a house
Backyard lot cleared and rough graded, shade trees kept

McLeansville ground conditions and how they shape land grading

East of Greensboro along US-70 and I-85, McLeansville is a wide stretch of rolling farm ground that's turning into subdivisions one field at a time. The high ground is Cecil clay, but pockets of Enon and Iredell show up around Mt. Hope Church Road and toward Gibsonville, and those spots are wet, slick and slow. Buffalo Creek and Reedy Fork both pass near here on their way to the Haw River, and the bottoms along them are Chewacla silt that floods in a hard rain. Fields that stopped being farmed grow up in loblolly first, then sweetgum and red cedar, with privet and honeysuckle underneath.

Around Reedy Fork, I-85 and NC-61, the properties we're usually called to look like this:

  • Shop and pole barn pads with gravel access lanes behind existing homes
  • Three- to ten-acre homesteads off Huffine Mill, Youngs Mill and Frieden Church Road with overgrown back acreage and lost fence lines
  • Storm-damaged tracts where downed loblolly needs cleanup and the brush mulched

What land grading jobs look like around McLeansville

A typical McLeansville call for land grading looks like this: Shop and pole barn pads with gravel access lanes behind existing homes. We've handled that exact situation around NC-61 and Huffine Mill Road more times than we can count.

The other common one is New construction lots before and after the build, which usually means a tighter work area and more care around what stays.

If your property is somewhere in between, send the address and we'll tell you which side of the line it falls on.

Neighbors in Gibsonville, Elon and Greensboro call us for the same work; McLeansville sits right in the middle of that route.

Why McLeansville property owners call A&R

Our grading estimates in McLeansville describe the cuts, the fills, the material coming in or going out, and the finish you'll get. Nothing vague. The number in the estimate is the number on the invoice.

A&R Land Services grades across Guilford County from our base in Greensboro. Contact us and we'll get your McLeansville lot on the schedule.

Land Grading in McLeansville: questions

Do I need a permit to grade my property in NC?

For most residential grading under an acre, no. If you disturb more than an acre, North Carolina's sediment and erosion control rules kick in and you'll need an approved plan, usually through the county or the state Division of Energy, Mineral and Land Resources. Towns can have their own stormwater rules on smaller areas. We'll tell you if your job trips a threshold.

What's the difference between grading and leveling?

Leveling makes ground flat. Grading makes it slope on purpose. A truly level yard holds water in our soils, so almost every job that starts as "I want it level" ends up as "I want it smooth with a gentle fall away from the house." That's grading, and it's what we do.

How far is A&R Land Services from McLeansville?

We're based in Greensboro, about 15 minutes from McLeansville. Guilford County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.

Do you handle land grading near Reedy Fork and I-85?

Yes. We work throughout McLeansville and the surrounding Guilford County area, including properties around Reedy Fork, I-85 and NC-61. If you're outside the town limits, send the address and we'll confirm it's in range.

What should I expect from a land grading job in Guilford County?

Driveway, parking and gravel lot base shaping is the most common version of it around McLeansville. We look at the site after a rain if we can, note where it pools and where it flows, check the existing slope with a laser, and talk through what the ground has to do once we're gone. Square footage or acreage being shaped is the factor that moves the price most on Guilford County jobs, and we'll walk through it with you on site.

Land Grading in McLeansville, done right the first time.

Call, text, or send a few photos and the address. Clark walks the property with you and puts a real number on the work.

(336) 392-8138Request an estimate