Veteran & Fireman Owned · Land clearing, forestry mulching & grading · Greensboro, NC & the Piedmont TriadCall or text (336) 392-8138
Forestry Mulching & Land Management · Yadkin County · 55 min from Greensboro

Yadkinville Trail Cutting

Walking trails, ATV paths and equipment access cut through the woods and left mulched.

If you can't get to the back of your Yadkinville property without a machete, we'll cut the route. Veteran and fireman owned, based in Greensboro, and trail work on Yadkin County recreational land is some of the most enjoyable work we do.

Hunting tracts around Yadkinville want trails that get you to the stand without walking through the bedding cover. We route those with the wind and the terrain in mind and keep the corridor just wide enough for a quiet walk or a UTV.

Trail entrance cut from a gravel drive into the woods with brush mulched back
Trail opened off the gravel drive
Kubota SVL97-2 track loader with Fecon forestry mulcher head working through brush and saplings in a Piedmont hardwood stand
Fecon mulcher head on the SVL97 — one pass takes brush and saplings to chips
Forestry mulcher threading between mature oak trunks while clearing understory
Selective clearing — keeper hardwoods stay, everything under them goes

Yadkinville ground conditions and how they shape trail cutting

Vineyard work is a big part of what we do here. The Yadkin Valley AVA runs through the county and growers off US-601, Shacktown Road and toward Boonville and Hamptonville need land cleared, graded and fence-lined before they plant. Cattle farms along NC-67 and Courtney-Huntsville Road call for pasture reclamation and fence rows cut back. Ten- and twenty-acre homesteads are coming out of the old farms along the US-421 corridor, and those jobs are house pads, septic areas, gravel drives and a couple of acres of pasture opened up.

Around Yadkin Valley AVA, Forbush and US-421, the properties we're usually called to look like this:

  • Former tobacco farms along US-421 being split into ten- to twenty-acre homesteads with pads, drives and pasture to clear
  • Timber tracts gone to loblolly that owners want thinned to pasture or opened for hunting
  • Pole barn and equipment shed pads on working farms

What trail cutting jobs look like around Yadkinville

A typical Yadkinville call for trail cutting looks like this: Former tobacco farms along US-421 being split into ten- to twenty-acre homesteads with pads, drives and pasture to clear. We've handled that exact situation around US-421 and Hamptonville more times than we can count.

The other common one is Walking and running loops on wooded homesites, which usually means a tighter work area and more care around what stays.

If your property is somewhere in between, send the address and we'll tell you which side of the line it falls on.

We also cover trail cutting in Dobson, East Bend and Boonville, so if you've got property in more than one spot we can often batch the work.

Why Yadkinville property owners call A&R

A mulched trail in Yadkinville is clean from day one — no windrow of brush along the edge, no stumps standing up, no burn pile smoldering by the path. Just a corridor through the woods with a chip floor.

Trail cutting in Yadkin County starts with a walk through the woods. Get in touch and let's lay it out.

Trail Cutting in Yadkinville: questions

Do you remove the stumps on the trail?

Stumps inside the corridor get mulched to grade — low enough that they won't catch a tire, a hoof or a boot. On stretches where you want bare dirt for gravel we pull them with the excavator. Most trail customers are fine with mulched stumps and a chip floor.

Can you cut a trail across a creek?

Yes. We pick the crossing where the banks are low and the bottom is firm, keep the clearing narrow inside the buffer, and either set stone for a ford or install a culvert with fill over it, depending on how much water runs and how often you need to cross it in the wet. The excavator and the dump trailer handle it on the same visit.

How far is A&R Land Services from Yadkinville?

We're based in Greensboro, about 55 minutes from Yadkinville. Yadkin County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.

Do you handle trail cutting near Yadkin Valley AVA and Forbush?

Yes. We work throughout Yadkinville and the surrounding Yadkin County area, including properties around Yadkin Valley AVA, Forbush and US-421. If you're outside the town limits, send the address and we'll confirm it's in range.

How do you approach trail cutting on Yadkinville ground?

Access routes to deer stands, food plots and hunting blinds is the most common version of it around Yadkinville. We walk the woods with you, lay out the trail with flagging tape, and adjust it for slope, drainage, keeper trees and creek crossings. If you want a loop, access to a stand or a lane to a field, that shapes the route. Access to the start of the trail from where we can unload is the factor that moves the price most on Yadkin County jobs, and we'll walk through it with you on site.

Trail Cutting in Yadkinville, done right the first time.

Call, text, or send a few photos and the address. Clark walks the property with you and puts a real number on the work.

(336) 392-8138Request an estimate