Veteran & Fireman Owned · Land clearing, forestry mulching & grading · Greensboro, NC & the Piedmont TriadCall or text (336) 392-8138
Forestry Mulching & Land Management · Durham County · 55 min from Greensboro

Durham Trail Cutting

Walking trails, ATV paths and equipment access cut through the woods and left mulched.

Wooded land in Durham is a lot more fun with a trail through it. A&R Land Services cuts walking loops, UTV paths and equipment lanes across Durham County with a forestry mulcher, leaving a chip floor you can ride the same day. We're about 55 minutes away in Greensboro.

Nearly every trail we cut in Durham County crosses a creek or a wet-weather branch. On Durham properties we place the crossing where the bottom's firm, keep the clearing narrow inside the buffer, and set stone or a culvert if you'll be driving it in the wet.

Trail entrance cut from a gravel drive into the woods with brush mulched back
Trail opened off the gravel drive
Kubota SVL97-2 track loader with Fecon forestry mulcher head working through brush and saplings in a Piedmont hardwood stand
Fecon mulcher head on the SVL97 — one pass takes brush and saplings to chips
Forestry mulcher threading between mature oak trunks while clearing understory
Selective clearing — keeper hardwoods stay, everything under them goes

Durham ground conditions and how they shape trail cutting

The work in Durham splits three ways. Inside the Durham Freeway loop it's small lot clearing — privet, wisteria, kudzu and sweetgum off infill lots in Walltown, East Durham and around NCCU that are finally getting built on. Along NC-751, Fayetteville Road and Hope Valley it's estate lots near Jordan Lake with understory mulching and view work. North of I-85 off Guess Road, Roxboro Road and Russell Road it's real acreage: old tobacco farms, timber, and horse properties where the pasture went to pine. The Eno, Little River and Flat River all run through the northern half on their way to Falls Lake.

Around Rougemont, the Little River and Duke Forest, the properties we're usually called to look like this:

  • Estate lots in Hope Valley, Treyburn and along NC-751 wanting understory mulched for views and fire safety
  • Falls Lake-adjacent tracts off Redwood Road and Old Oxford Road with buffer-limited clearing and trail work
  • Commercial outparcels around RTP, NC-55 and US-70 east needing rough grading and debris removal

What trail cutting jobs look like around Durham

Most of our trail cutting work in Durham comes from two directions. First, estate lots in Hope Valley, Treyburn and along NC-751 wanting understory mulched for views and fire safety. Second, connecting a house to a creek, pond or picnic spot through the woods.

Both show up regularly along Duke Forest and the Durham Freeway (NC-147), and both are jobs we can usually walk, quote and schedule inside a couple of weeks.

If you're just outside Durham — Chapel Hill, Raleigh, Roxboro or anywhere between — you're still inside our regular range.

Why Durham property owners call A&R

Greensboro to Durham is about 55 minutes, which keeps a half-day trail job worth doing and makes it easy to come back and add a loop or a spur later.

Send us an aerial with the route sketched in and a couple of photos of the woods. We'll give you a real number for cutting it in Durham.

Trail Cutting in Durham: questions

How wide should an ATV or UTV trail be?

Eight feet is the minimum for a side-by-side to pass comfortably, and ten feet gives you room on turns and lets two riders meet. Walking trails are fine at four to six feet. Equipment access for a tractor or truck wants twelve or more. We cut to the use and keep the turns gentle enough for whatever's riding it.

Can you cut a trail across a creek?

Yes. We pick the crossing where the banks are low and the bottom is firm, keep the clearing narrow inside the buffer, and either set stone for a ford or install a culvert with fill over it, depending on how much water runs and how often you need to cross it in the wet. The excavator and the dump trailer handle it on the same visit.

How far is A&R Land Services from Durham?

We're based in Greensboro, about 55 minutes from Durham. Durham County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.

Do you handle trail cutting near Rougemont and the Little River?

Yes. We work throughout Durham and the surrounding Durham County area, including properties around Rougemont, the Little River and Duke Forest. If you're outside the town limits, send the address and we'll confirm it's in range.

How do you approach trail cutting on Durham ground?

Walking and running loops on wooded homesites is the most common version of it around Durham. The mulcher follows the flags, taking brush and saplings to grade and working around the trees you're keeping. Low limbs that would catch a rider get cut. Larger trees on the route get a decision — route around or fell and grapple off. Gravel on climbs, wet stretches or the whole trail is the factor that moves the price most on Durham County jobs, and we'll walk through it with you on site.

Trail Cutting in Durham, done right the first time.

Call, text, or send a few photos and the address. Clark walks the property with you and puts a real number on the work.

(336) 392-8138Request an estimate