A driveway entrance in High Point is only as good as the pipe under it. A&R Land Services installs and replaces culverts throughout Guilford County — new entrances, crushed pipe, undersized pipe that backs the ditch up — and we set every one to grade on stone bedding so it stays put. We're about 25 minutes away in Greensboro.
Guilford County ditches carry more water than people think. A roadside ditch below a wooded hillside or a pasture can fill a 15-inch pipe in a thunderstorm, and that's when the entrance goes over the drive. We look at the drainage area above your High Point driveway before we pick a pipe size.



High Point ground conditions and how they shape culverts
Watershed rules matter here because both city lakes are drinking water supply. Anything inside the Oak Hollow or High Point Lake critical areas gets looked at for impervious cover and buffers, so we keep mulched material in place as ground cover and stay off the stream edges. Timing-wise, late summer through November is when the Enon flats dry enough to grade properly. We'll still mulch standing brush in February, but we won't cut finished grade in a bottom until it's firm.
Around the Emerywood and Oak Hollow Estates neighborhoods, Rich Fork Creek and Eastchester Drive (NC-68), the properties we're usually called to look like this:
- Older subdivisions on the west side where privet and honeysuckle have taken over the fence lines between neighbors
- Two- to five-acre wooded build lots north of town around Skeet Club Road, Sandy Ridge Road and Johnson Street that have grown up in loblolly and privet
- Small commercial outparcels along Wendover Avenue and I-74 that need a cleared, leveled pad before a developer will look at them
What culverts jobs look like around High Point
Around Eastchester Drive (NC-68), the properties that call us for culverts tend to be older subdivisions on the west side where privet and honeysuckle have taken over the fence lines between neighbors.
Closer to North Main Street it's more often entrances that flood or wash out every big storm — different layout, same machine, and the estimate reflects the difference honestly.
High Point isn't one kind of ground, and we don't price it like it is.
Neighbors in Archdale, Thomasville and Colfax call us for the same work; High Point sits right in the middle of that route.
Why High Point property owners call A&R
Being about 25 minutes from High Point means a culvert replacement is usually a single-day trip for us, not a two-day mobilization. That shows up in the price, and it means we can get to a washed-out entrance quickly after a storm.
For culvert installation and replacement in High Point and the rest of Guilford County, call (336) 392-8138. Free estimates, properly sized pipe, and an entrance that holds.
Culverts in High Point: questions
How much does it cost to install a driveway culvert in NC?
The main drivers are pipe size and length, whether an old pipe has to come out, and how much stone the backfill and end treatments take. A short 15-inch HDPE pipe on a private drive is a half-day job. A 24-inch, 40-foot pipe on a state road with riprap ends and a full ditch reshape is a bigger day with a lot more material. We give a free written estimate after seeing the site.
Can you replace a crushed culvert pipe?
Yes, and it's one of the most common jobs we do. The excavator pulls the old pipe, we clean out the silt, cut the trench to the right grade, set new pipe on stone bedding and rebuild the drive over it. If the old pipe was undersized or set too high, we fix that at the same time.
How far is A&R Land Services from High Point?
We're based in Greensboro, about 25 minutes from High Point. Guilford County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle culverts near the Emerywood and Oak Hollow Estates neighborhoods and Rich Fork Creek?
Yes. We work throughout High Point and the surrounding Guilford County area, including properties around the Emerywood and Oak Hollow Estates neighborhoods, Rich Fork Creek and Eastchester Drive (NC-68). If you're outside the town limits, send the address and we'll confirm it's in range.
What does culverts typically involve on a High Point property?
Long driveways that cross a low spot or seasonal stream is the most common version of it around High Point. Pipe size and material, length, end treatment, stone quantity and how the drive gets tied back in. If an old pipe is coming out, the estimate covers removal and disposal too. Material: HDPE, corrugated metal or reinforced concrete is the factor that moves the price most on Guilford County jobs, and we'll walk through it with you on site.