A&R Land Services repairs gullies, rebuilds slopes and gets cover back on bare ground in McLeansville. Most of the work is dirt and stone in the right places — slow the water, spread it out, armor what has to carry it — and we're only about 15 minutes from McLeansville.
Driveways and farm roads around McLeansville are frequent erosion sources — a ditch with no outlet, a crown that's gone flat, a culvert end with no stone. Fixing the road drainage is often the first and cheapest step toward stopping the erosion below it in Guilford County.



McLeansville ground conditions and how they shape erosion control
East of Greensboro along US-70 and I-85, McLeansville is a wide stretch of rolling farm ground that's turning into subdivisions one field at a time. The high ground is Cecil clay, but pockets of Enon and Iredell show up around Mt. Hope Church Road and toward Gibsonville, and those spots are wet, slick and slow. Buffalo Creek and Reedy Fork both pass near here on their way to the Haw River, and the bottoms along them are Chewacla silt that floods in a hard rain. Fields that stopped being farmed grow up in loblolly first, then sweetgum and red cedar, with privet and honeysuckle underneath.
Around NC-61, Eastern Guilford High School and I-85, the properties we're usually called to look like this:
- Three- to ten-acre homesteads off Huffine Mill, Youngs Mill and Frieden Church Road with overgrown back acreage and lost fence lines
- Old dairy and tobacco farms being divided into family parcels, each needing a house site and drive
- Subdivision build lots along McLeansville Road and NC-61 needing pine thickets cleared and pads leveled
What erosion control jobs look like around McLeansville
A typical McLeansville call for erosion control looks like this: Three- to ten-acre homesteads off Huffine Mill, Youngs Mill and Frieden Church Road with overgrown back acreage and lost fence lines. We've handled that exact situation around I-85 and Youngs Mill Road more times than we can count.
The other common one is Property above a creek that needs to stop sending silt downstream, which usually means a tighter work area and more care around what stays.
If your property is somewhere in between, send the address and we'll tell you which side of the line it falls on.
If you're just outside McLeansville — Whitsett, Browns Summit, Gibsonville or anywhere between — you're still inside our regular range.
Why McLeansville property owners call A&R
The guy on the machine on your McLeansville erosion job is Clark — veteran, firefighter, owner. He's the one who walks the slope with you, and he's the one who comes back after the first storm to make sure it held.
Don't let a small wash on your McLeansville property become a gully. Reach out to A&R Land Services for a free erosion control estimate anywhere in Guilford County.
Erosion Control in McLeansville: questions
How do I stop erosion on a slope in red clay?
Three things, in order: keep water from concentrating on the slope by diverting it at the top, reshape the slope so what does run sheets off instead of channeling, and get cover on the clay — seed and straw, mulch or erosion blanket. Clay only erodes when it's bare and water is moving fast. Fix those two conditions and it stops.
Do I need a permit for erosion control work in NC?
For small repairs on your own property, no. North Carolina's Sedimentation Pollution Control Act kicks in when you disturb more than an acre, and that requires an erosion and sediment control plan approved by the state or your county. Work inside a stream buffer has its own rules. We'll tell you if your project crosses either line.
How far is A&R Land Services from McLeansville?
We're based in Greensboro, about 15 minutes from McLeansville. Guilford County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle erosion control near NC-61 and Eastern Guilford High School?
Yes. We work throughout McLeansville and the surrounding Guilford County area, including properties around NC-61, Eastern Guilford High School and I-85. If you're outside the town limits, send the address and we'll confirm it's in range.
What should I expect from a erosion control job in Guilford County?
Gullies cutting through pasture, lawns and wooded lots is the most common version of it around McLeansville. We trace where water concentrates, where it's cutting, and where it ends up. Most erosion problems start uphill of where the damage shows, so we look at the whole drainage path. Whether the disturbed area triggers a state erosion control plan is the factor that moves the price most on Guilford County jobs, and we'll walk through it with you on site.