Veteran & Fireman Owned · Land clearing, forestry mulching & grading · Greensboro, NC & the Piedmont TriadCall or text (336) 392-8138
Forestry Mulching & Land Management · Davie County · 45 min from Greensboro

Bermuda Run Trail Cutting

Walking trails, ATV paths and equipment access cut through the woods and left mulched.

A side-by-side loop, a path to the deer stand, a lane to the hay field you haven't reached in years — whatever the trail is for on your Bermuda Run property, we cut it to that width and that purpose.

The woods around Bermuda Run are mostly hardwood slopes with a privet and honeysuckle understory, which cuts cleanly. We route trails along the contour on Davie County slopes so they don't gully out after the first wet winter.

Trail entrance cut from a gravel drive into the woods with brush mulched back
Trail opened off the gravel drive
Kubota SVL97-2 track loader with Fecon forestry mulcher head working through brush and saplings in a Piedmont hardwood stand
Fecon mulcher head on the SVL97 — one pass takes brush and saplings to chips
Forestry mulcher threading between mature oak trunks while clearing understory
Selective clearing — keeper hardwoods stay, everything under them goes

Bermuda Run ground conditions and how they shape trail cutting

Our Bermuda Run work is lot-scale and finish-oriented. Owners in the country club and the newer sections off Yadkin Valley Road and Kinderton want the understory mulched so the lot looks like a park, a view opened toward the river, or a half-acre of jungle behind the house turned into usable lawn. We also handle builders clearing the last wooded lots in the subdivisions near the I-40 interchange and grading pads on the remaining commercial parcels around Kinderton Village. Across the river, Tanglewood and Clemmons are close enough that we cover them from the same trip.

Around Hillsdale, Bermuda Run Country Club and Yadkin Valley Road, the properties we're usually called to look like this:

  • Riverfront and bluff lots on the Yadkin side of town where owners want a view opened within the buffer rules
  • Last remaining wooded builder lots near the I-40 interchange needing full lot clearing and pad grading
  • Small commercial parcels around Kinderton Village needing rough grading and debris removal

What trail cutting jobs look like around Bermuda Run

A typical Bermuda Run call for trail cutting looks like this: Riverfront and bluff lots on the Yadkin side of town where owners want a view opened within the buffer rules. We've handled that exact situation around Yadkin Valley Road and Blue Heron Trail more times than we can count.

The other common one is Horse trails and riding paths on farm property, which usually means a tighter work area and more care around what stays.

If your property is somewhere in between, send the address and we'll tell you which side of the line it falls on.

We also cover trail cutting in Winston Salem, Lewisville and Mocksville, so if you've got property in more than one spot we can often batch the work.

Why Bermuda Run property owners call A&R

We flag the route with you before the mulcher starts, so the trail goes where you want it and around the trees you care about. The estimate names the length, width, crossings and any gravel, and the number holds.

For trails, UTV loops and equipment lanes in Bermuda Run, call (336) 392-8138. The owner routes it, cuts it and rides it with you.

Trail Cutting in Bermuda Run: questions

Do you remove the stumps on the trail?

Stumps inside the corridor get mulched to grade — low enough that they won't catch a tire, a hoof or a boot. On stretches where you want bare dirt for gravel we pull them with the excavator. Most trail customers are fine with mulched stumps and a chip floor.

Will the trail turn into mud?

Not if it's routed right. A trail that runs straight down a slope on Piedmont clay becomes a gully; one that follows the contour and crosses slopes at an angle sheds water. We route for drainage, keep the mulch layer on the path, and put gravel on any stretch that's going to be wet no matter what — usually creek approaches and the bottom of climbs.

How far is A&R Land Services from Bermuda Run?

We're based in Greensboro, about 45 minutes from Bermuda Run. Davie County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.

Do you handle trail cutting near Hillsdale and Bermuda Run Country Club?

Yes. We work throughout Bermuda Run and the surrounding Davie County area, including properties around Hillsdale, Bermuda Run Country Club and Yadkin Valley Road. If you're outside the town limits, send the address and we'll confirm it's in range.

How do you approach trail cutting on Bermuda Run ground?

Fire and emergency access through dense acreage is the most common version of it around Bermuda Run. We walk the woods with you, lay out the trail with flagging tape, and adjust it for slope, drainage, keeper trees and creek crossings. If you want a loop, access to a stand or a lane to a field, that shapes the route. Creek and wet crossings and whether they get stone or a culvert is the factor that moves the price most on Davie County jobs, and we'll walk through it with you on site.

Trail Cutting in Bermuda Run, done right the first time.

Call, text, or send a few photos and the address. Clark walks the property with you and puts a real number on the work.

(336) 392-8138Request an estimate