A&R cuts trails through Guilford County woods without a pile of brush beside the path or a burn permit. The mulcher grinds the corridor to chips, the roots hold the clay, and your Climax trail is walkable before the trailer's hooked up.
Red clay climbs in Guilford County woods get slick under ATV tires. We put the climbs where the ground is firmest, angle them across the slope, and gravel the ones that are going to be wet regardless.



Climax ground conditions and how they shape trail cutting
This is still working farm country, so the jobs run bigger: twenty- to one-hundred-acre tracts off NC-22, Climax Road and Old Liberty Road where the owner wants pasture back, a cattle lane cut, a pond-side cleaned up, or a hunting tract opened with lanes and a firebreak. Poultry houses are scattered through here, and we've built pads and access roads for several. Closer to US-421 and the Pleasant Garden line, new houses are going up on five- to ten-acre pieces and need the pine thicket mulched and a drive graded in.
Around Randleman Lake, Old Liberty Road and the Guilford–Randolph county line, the properties we're usually called to look like this:
- Pond banks and creek edges on old farms that have grown up in sweetgum and privet
- Five- to ten-acre home sites near US-421 wanting the thicket mulched and a drive graded
- Poultry farm pads and gravel access roads on the Randolph side
What trail cutting jobs look like around Climax
A typical Climax call for trail cutting looks like this: Pond banks and creek edges on old farms that have grown up in sweetgum and privet. We've handled that exact situation around the Guilford–Randolph county line and Big Alamance Creek more times than we can count.
The other common one is Horse trails and riding paths on farm property, which usually means a tighter work area and more care around what stays.
If your property is somewhere in between, send the address and we'll tell you which side of the line it falls on.
We also cover trail cutting in Julian, Greensboro and Liberty, so if you've got property in more than one spot we can often batch the work.
Why Climax property owners call A&R
The owner cuts every Climax trail himself. Clark is a veteran and a working firefighter, and he's laid out enough routes through Guilford County woods to know where a trail will hold and where it'll wash.
Open up your Climax property. Reach out to A&R Land Services for trail and access path cutting anywhere in Guilford County.
Trail Cutting in Climax: questions
Will the trail turn into mud?
Not if it's routed right. A trail that runs straight down a slope on Piedmont clay becomes a gully; one that follows the contour and crosses slopes at an angle sheds water. We route for drainage, keep the mulch layer on the path, and put gravel on any stretch that's going to be wet no matter what — usually creek approaches and the bottom of climbs.
How wide should an ATV or UTV trail be?
Eight feet is the minimum for a side-by-side to pass comfortably, and ten feet gives you room on turns and lets two riders meet. Walking trails are fine at four to six feet. Equipment access for a tractor or truck wants twelve or more. We cut to the use and keep the turns gentle enough for whatever's riding it.
How far is A&R Land Services from Climax?
We're based in Greensboro, about 25 minutes from Climax. Guilford County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle trail cutting near Randleman Lake and Old Liberty Road?
Yes. We work throughout Climax and the surrounding Guilford County area, including properties around Randleman Lake, Old Liberty Road and the Guilford–Randolph county line. If you're outside the town limits, send the address and we'll confirm it's in range.
How do you approach trail cutting on Climax ground?
Fire and emergency access through dense acreage is the most common version of it around Climax. We walk the woods with you, lay out the trail with flagging tape, and adjust it for slope, drainage, keeper trees and creek crossings. If you want a loop, access to a stand or a lane to a field, that shapes the route. Creek and wet crossings and whether they get stone or a culvert is the factor that moves the price most on Guilford County jobs, and we'll walk through it with you on site.