Veteran & Fireman Owned · Land clearing, forestry mulching & grading · Greensboro, NC & the Piedmont TriadCall or text (336) 392-8138
Forestry Mulching & Land Management · Davidson County · 45 min from Greensboro

Trail Cutting in Lexington, NC

Walking trails, ATV paths and equipment access cut through the woods and left mulched.

If you can't get to the back of your Lexington property without a machete, we'll cut the route. Veteran and fireman owned, based in Greensboro, and trail work on Davidson County recreational land is some of the most enjoyable work we do.

Hunting tracts around Lexington want trails that get you to the stand without walking through the bedding cover. We route those with the wind and the terrain in mind and keep the corridor just wide enough for a quiet walk or a UTV.

Trail entrance cut from a gravel drive into the woods with brush mulched back
Trail opened off the gravel drive
Kubota SVL97-2 track loader with Fecon forestry mulcher head working through brush and saplings in a Piedmont hardwood stand
Fecon mulcher head on the SVL97 — one pass takes brush and saplings to chips
Forestry mulcher threading between mature oak trunks while clearing understory
Selective clearing — keeper hardwoods stay, everything under them goes

Lexington ground conditions and how they shape trail cutting

Lexington is the center of Davidson County and the land around it runs from the Yadkin River on the west to the Uwharrie foothills on the southeast, which means we see three kinds of dirt in one town. North and west toward Tyro and Reeds it is Cecil, Appling and Pacolet red clay; around the city itself and east toward Abbotts Creek it is Enon, Iredell and Mecklenburg shrink-swell clay over diabase; and south toward Southmont and High Rock Lake the Badin and Tatum slate-belt soils start. Abbotts Creek, Swearing Creek and Leonard Creek drain toward the Yadkin, and all three have wide Chewacla bottoms.

Around Old US-64, Abbotts Creek and Cotton Grove Road, the properties we're usually called to look like this:

  • High Rock Lake lots at Southmont and along NC-8 and Cotton Grove Road needing privet and sweetgum cleared for a view, plus pads and driveways on steep ground
  • Abbotts Creek and Swearing Creek bottomland owners want opened for hay, wildlife or a pond
  • Cattle and grain farms toward Tyro, Reeds and Linwood with pasture gone to pine and fence rows lost to honeysuckle

What trail cutting jobs look like around Lexington

If you're near Cotton Grove Road or Winston Road, odds are your situation is one we've already worked: high Rock Lake lots at Southmont and along NC-8 and Cotton Grove Road needing privet and sweetgum cleared for a view, plus pads and driveways on steep ground, or horse trails and riding paths on farm property.

The trail cutting approach for Davidson County ground is the same either way — look first, quote in writing, bring the right attachment, walk it with you when it's done.

We also cover trail cutting in Salisbury, Denton and Mocksville, so if you've got property in more than one spot we can often batch the work.

Why Lexington property owners call A&R

A mulched trail in Lexington is clean from day one — no windrow of brush along the edge, no stumps standing up, no burn pile smoldering by the path. Just a corridor through the woods with a chip floor.

Trail cutting in Davidson County starts with a walk through the woods. Get in touch and let's lay it out.

Trail Cutting in Lexington: questions

How much does it cost to cut a trail through the woods?

Trails are priced by length, width and how thick the woods are, with creek crossings and gravel as the add-ons. A quarter mile of walking path through open hardwoods is a short day. A mile of ten-foot UTV loop through privet with two creek crossings and gravel on the climbs is a multi-day job. We flag the route with you and give a written number. Estimates are free.

Will the trail turn into mud?

Not if it's routed right. A trail that runs straight down a slope on Piedmont clay becomes a gully; one that follows the contour and crosses slopes at an angle sheds water. We route for drainage, keep the mulch layer on the path, and put gravel on any stretch that's going to be wet no matter what — usually creek approaches and the bottom of climbs.

How far is A&R Land Services from Lexington?

We're based in Greensboro, about 45 minutes from Lexington. Davidson County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.

Do you handle trail cutting near Old US-64 and Abbotts Creek?

Yes. We work throughout Lexington and the surrounding Davidson County area, including properties around Old US-64, Abbotts Creek and Cotton Grove Road. If you're outside the town limits, send the address and we'll confirm it's in range.

What should I expect from a trail cutting job in Davidson County?

Fire and emergency access through dense acreage is the most common version of it around Lexington. Creek crossings get stone or a culvert if scoped. Wet stretches and climbs get gravel if you want them drivable year-round. We make a final pass to knock stubs flush and leave a clean mulch floor. Creek and wet crossings and whether they get stone or a culvert is the factor that moves the price most on Davidson County jobs, and we'll walk through it with you on site.

Trail Cutting in Lexington, done right the first time.

Call, text, or send a few photos and the address. Clark walks the property with you and puts a real number on the work.

(336) 392-8138Request an estimate