The ground in Welcome is red clay, and red clay makes a great pad or a terrible one depending on who built it. A&R Land Services is about 45 minutes from Welcome, and we build pads the way the material demands: in lifts, at the right moisture, compacted as we go.
The pads we build around Welcome are mostly on the sloped parcels left after the flat ground got developed. That means a cut on the high side and a compacted fill on the low side, and the fill is where the care goes. We place it in six-to-eight-inch layers and track in every one before the next goes down.



Welcome ground conditions and how they shape building pads
Our Welcome work leans toward small farms and new homes. Buyers along Friendship Road, Hampton Road and Welcome-Arcadia Road are picking up five to twenty acres of old farmland for horses, a shop or a vineyard and need the pine and cedar off the pasture, fence lines found, and a pad and driveway cut. The Midway and Arcadia side is filling in with subdivisions off Old US-52 and NC-150, and those need lot clearing and grading. We also get called by the vineyards and race shops for commercial brush clearing, parking lot grading and drainage around their properties.
Around Hampton Road, Friendship Road and Muddy Creek, the properties we're usually called to look like this:
- Five to twenty acre farm parcels off Friendship Road, Hampton Road and Welcome-Arcadia Road being set up for horses, shops and small vineyards
- Swearing Creek bottomland the owner wants cleaned up for hay or a pond
- Vineyard and race-shop properties needing commercial brush clearing, lot grading and drainage
What building pads jobs look like around Welcome
Most of our building pads work in Welcome comes from two directions. First, five to twenty acre farm parcels off Friendship Road, Hampton Road and Welcome-Arcadia Road being set up for horses, shops and small vineyards. Second, sloped lots that need a cut-and-fill pad to hold a level floor.
Both show up regularly along Muddy Creek and Welcome-Arcadia Road, and both are jobs we can usually walk, quote and schedule inside a couple of weeks.
If you're just outside Welcome — Wallburg, Advance, Winston Salem or anywhere between — you're still inside our regular range.
Why Welcome property owners call A&R
We build Davidson County pads to the finished floor elevation on the plan, checked with a laser, with corners staked and overbuild for the crew. Builders in Welcome get a pad they can trust without re-shooting it.
We'll walk the Welcome lot with you or your builder, measure the cut and fill, and give you a written price for the pad.
Building Pads in Welcome: questions
Can you build a pad on a sloped lot?
That's most of what we do. On a slope the pad is cut into the high side and filled on the low side, with the fill compacted in lifts so the downhill edge doesn't settle. Steep lots sometimes need a retaining wall or an engineered fill section; we'll tell you if yours is one of those before we quote it.
Do you need a permit to build a pad?
The pad itself usually falls under your building permit, which the builder or the owner pulls through the county inspections office. If the total disturbed area on the lot goes over an acre, a state sediment and erosion control plan is required too. We'll help you figure out which applies before we start.
How far is A&R Land Services from Welcome?
We're based in Greensboro, about 45 minutes from Welcome. Davidson County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle building pads near Hampton Road and Friendship Road?
Yes. We work throughout Welcome and the surrounding Davidson County area, including properties around Hampton Road, Friendship Road and Muddy Creek. If you're outside the town limits, send the address and we'll confirm it's in range.
How do you approach building pads on Welcome ground?
New home sites on crawl space, slab or basement foundations is the most common version of it around Welcome. Fill placed in six-to-eight-inch layers and tracked in before the next goes on. Geotech density testing coordinated between lifts if the project requires it. Pad size and how much overbuild the foundation crew needs is the factor that moves the price most on Davidson County jobs, and we'll walk through it with you on site.