If you're building in Wallburg and the lot has been cleared, the pad is the next step. We're about 35 minutes away in Greensboro, and we build pads to the builder's finished floor elevation with the fill compacted properly, because loose Davidson County clay is the main reason foundations here move.
Metal building and pole barn pads are a steady part of our Wallburg work. Those slabs are big and thin, which makes them sensitive to settlement, so the pad under them has to be uniformly compacted edge to edge. We build them with the overbuild the slab crew needs and check them with a laser.



Wallburg ground conditions and how they shape building pads
Abbotts Creek is the headwater of Lake Thom-A-Lex, so Davidson County enforces watershed buffers here and keeps a close eye on sediment from the subdivision work. We keep silt fence staged and seed bare ground within the week on every job. The Enon and Iredell flats near the creek heads are the wet-season problem and get pushed to summer, while the Cecil ridges along NC-109 can be graded most of the year. Shrink-swell clay means pads need drainage planned from the start.
Around NC-109, Wallburg Road and Lake Thom-A-Lex watershed, the properties we're usually called to look like this:
- Subdivision tracts along NC-109, Hickory Tree Road and Wallburg Road needing full clearing and rough grading
- Single wooded acre lots next to existing homes being cleared for a new build
- Abbotts Creek headwater parcels that must be cleared under Lake Thom-A-Lex watershed rules
What building pads jobs look like around Wallburg
A typical Wallburg call for building pads looks like this: Subdivision tracts along NC-109, Hickory Tree Road and Wallburg Road needing full clearing and rough grading. We've handled that exact situation around Lake Thom-A-Lex watershed and Friedberg Road more times than we can count.
The other common one is Concrete slabs for equipment sheds, carports and patios, which usually means a tighter work area and more care around what stays.
If your property is somewhere in between, send the address and we'll tell you which side of the line it falls on.
If you're just outside Wallburg — Trinity, Kernersville, Welcome or anywhere between — you're still inside our regular range.
Why Wallburg property owners call A&R
We'll tell you up front whether your Wallburg pad needs engineered fill and geotech testing. We're not a general contractor or an engineer; we're the dirt crew, and we'd rather set you up right than have you find out later.
A&R Land Services is about 35 minutes from Wallburg. Reach out and we'll get your Davidson County pad built before the footings are due.
Building Pads in Wallburg: questions
Do building pads need to be compacted?
Yes, and it's the whole point. Loose clay settles for years, and anything built on it moves with it. We place fill in thin lifts and compact each one with the machine as it goes down. For slabs, steel buildings and anything with an engineered foundation, your builder may require tested density, and we work to the geotech's spec and coordinate their inspections.
How much does it cost to build a house pad in NC?
The cost is mostly in the dirt. A pad on a flat lot where the fill comes from the same site is a day or two of machine time and the low end. A pad on a slope that needs several feet of imported fill compacted in lifts, with geotech testing, is a bigger project and sits well above that. We stake it, measure the cut and fill, and give you a written number before anything moves.
How far is A&R Land Services from Wallburg?
We're based in Greensboro, about 35 minutes from Wallburg. Davidson County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle building pads near NC-109 and Wallburg Road?
Yes. We work throughout Wallburg and the surrounding Davidson County area, including properties around NC-109, Wallburg Road and Lake Thom-A-Lex watershed. If you're outside the town limits, send the address and we'll confirm it's in range.
What does building pads typically involve on a Wallburg property?
Sloped lots that need a cut-and-fill pad to hold a level floor is the most common version of it around Wallburg. We review the site plan, stake the footprint with working room around it, set a laser benchmark to the finished floor elevation, and work out cut and fill. Pad size and how much overbuild the foundation crew needs is the factor that moves the price most on Davidson County jobs, and we'll walk through it with you on site.