If you can't get to the back of your Whitsett property without a machete, we'll cut the route. Veteran and fireman owned, based in Greensboro, and trail work on Guilford County recreational land is some of the most enjoyable work we do.
Hunting tracts around Whitsett want trails that get you to the stand without walking through the bedding cover. We route those with the wind and the terrain in mind and keep the corridor just wide enough for a quiet walk or a UTV.



Whitsett ground conditions and how they shape trail cutting
Rock Creek and Big Alamance Creek both drain to the Haw River and on to Jordan Lake, so stream buffer rules apply on the creek-side parcels, and we keep disturbed ground well back from the banks. The Iredell clay on the flats is the main challenge — it's miserable to grade wet and cracks wide open in a drought — so we watch the forecast and plan the fine grading for dry stretches. Mulching, by contrast, we can do nearly year-round on the firmer Cecil ground along NC-61.
Around Rock Creek Dairy Road, I-85 / I-40 and US-70 (Burlington Road), the properties we're usually called to look like this:
- Old farm fence rows choked with honeysuckle and wild rose that owners want cut back to run new fence
- Commercial outparcels and logistics-adjacent tracts along Rock Creek Dairy Road and I-85 needing clearing and rough grading before sale
- Five- to twenty-acre rural home sites off NC-61 and Mt. Hope Church Road with a house, pole barn and gravel drive going in
What trail cutting jobs look like around Whitsett
Around US-70 (Burlington Road), the properties that call us for trail cutting tend to be old farm fence rows choked with honeysuckle and wild rose that owners want cut back to run new fence.
Closer to NC-61 it's more often access routes to deer stands, food plots and hunting blinds — different layout, same machine, and the estimate reflects the difference honestly.
Whitsett isn't one kind of ground, and we don't price it like it is.
Neighbors in Greensboro, Julian and Mcleansville call us for the same work; Whitsett sits right in the middle of that route.
Why Whitsett property owners call A&R
A mulched trail in Whitsett is clean from day one — no windrow of brush along the edge, no stumps standing up, no burn pile smoldering by the path. Just a corridor through the woods with a chip floor.
Trail cutting in Guilford County starts with a walk through the woods. Get in touch and let's lay it out.
Trail Cutting in Whitsett: questions
Will the trail turn into mud?
Not if it's routed right. A trail that runs straight down a slope on Piedmont clay becomes a gully; one that follows the contour and crosses slopes at an angle sheds water. We route for drainage, keep the mulch layer on the path, and put gravel on any stretch that's going to be wet no matter what — usually creek approaches and the bottom of climbs.
Can you cut a trail across a creek?
Yes. We pick the crossing where the banks are low and the bottom is firm, keep the clearing narrow inside the buffer, and either set stone for a ford or install a culvert with fill over it, depending on how much water runs and how often you need to cross it in the wet. The excavator and the dump trailer handle it on the same visit.
How far is A&R Land Services from Whitsett?
We're based in Greensboro, about 18 minutes from Whitsett. Guilford County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle trail cutting near Rock Creek Dairy Road and I-85 / I-40?
Yes. We work throughout Whitsett and the surrounding Guilford County area, including properties around Rock Creek Dairy Road, I-85 / I-40 and US-70 (Burlington Road). If you're outside the town limits, send the address and we'll confirm it's in range.
What does trail cutting typically involve on a Whitsett property?
Horse trails and riding paths on farm property is the most common version of it around Whitsett. A written plan with the trail's length and width, where crossings are, any gravel or culvert work included, and the price. Trails are quoted by the job after the walk. Growth density along the route — privet versus open hardwoods is the factor that moves the price most on Guilford County jobs, and we'll walk through it with you on site.