Veteran & Fireman Owned · Land clearing, forestry mulching & grading · Greensboro, NC & the Piedmont TriadCall or text (336) 392-8138
Hunting Land · 9 min read

Preparing Hunting Land in NC: Shooting Lanes, Food Plots and Access Trails

Timing and layout for NC hunting tracts — mulching shooting lanes, clearing and prepping food plots on red clay, cutting quiet access trails, and when to do it.

By Clark Sellars, Owner & OperatorJuly 14, 2026

Work backward from the season

In the Piedmont, archery deer season opens in September and gun season runs into early January, with turkey in April and May. That calendar drives everything. Fall food plots need to be in the ground by late August or September, which means the clearing and soil work has to happen in July and August. Shooting lanes and trails should be cut by late summer so the woods have a few weeks to settle before you're hunting them.

We get the panicked calls in October. By then, running a track loader through the woods you're about to hunt isn't a great idea, and anything you plant won't be up before the rut. Call us in spring or early summer for fall hunting, and we'll plan the whole tract around it.

Shooting lanes: how wide, how long, where

A shooting lane is a cleared corridor from a stand to where deer are likely to be — a trail, a creek crossing, a plot edge. For a bow stand, lanes are short and narrow: a few lanes, each ten to fifteen feet wide and thirty to forty yards long, cut radiating from the tree. For a rifle stand, longer and wider: a hundred to two hundred yards, wide enough to see a deer broadside.

We mulch the lanes, not push them, because mulching leaves the ground undisturbed and doesn't leave piles that deer avoid and that block your view. Stumps go low so you can walk and drive a side-by-side. We cut the lane so it bends slightly if you want to avoid a straight shot visible from the road or a neighbor's property.

Sweetgum and loblolly regrowth will fill a lane in two or three years, so plan to mow or mulch them again. A mulched lane also makes a great plot edge — plant it in clover and it doubles as a travel corridor and a food source.

Food plots on red clay

A plot is a full clearing job, not a mulching job. The trees come out, the stumps come out, and the ground gets disked. A mulched surface with roots in it can't be planted with a drill or a disc. We grub the stumps with the stump bucket and root rake, pile and burn or haul the debris, and rough grade so you can work it with a tractor.

Soil is the problem on most Piedmont plots. Old woodland soil is acidic, low in organic matter, and either compacted clay or thin topsoil over clay. Pull a soil test — the state lab does it free most of the year — and expect to lime heavily, two tons an acre or more, and fertilize. Lime takes months to work, so apply it as soon as the plot is cleared.

Size and shape: deer use small, irregular plots in cover more than big open fields. A half-acre to two-acre plot with a ragged edge, oriented so the prevailing wind carries your scent away from the approach, is better than five acres of clean rectangle. Multiple small plots scattered across a tract beat one big one.

What to plant, and when

Fall plots in the Piedmont: cereal rye, oats, wheat, crimson or ladino clover, brassicas like turnips and rape. Seed late August through September, after a rain if possible. Clover takes a year to really establish but then feeds deer and turkeys nearly year-round. Rye and oats come up fast and pull deer in for bow season.

Spring plots: soybeans, cowpeas, lablab, sunflowers for doves. Plant in late April or May after frost. Spring plots on a small acreage get browsed to nothing by July unless you've got a lot of acres planted, so most Piedmont landowners focus on fall plots and clover.

The NC Wildlife Resources Commission and the county extension offices have planting guides for this region. Follow them over whatever a seed bag at the big box store says.

Access trails and getting in quiet

A tract you can't get into without crashing through briars is a tract where deer know you're coming. We cut trails wide enough for a side-by-side or a truck — eight to ten feet — along the edges of the property or behind terrain so you can reach stands from downwind without crossing bedding areas. Mulched trails are quiet to walk and don't rut like a pushed trail.

Where a trail crosses a wet draw or a creek, we put in a culvert or build a hardened crossing with stone over fabric, so you're not stuck in April or tearing up the bank every trip. On steep sections we put in water bars to keep the trail from washing out.

Keep the trail network off the obvious deer travel corridors where you can. A trail that runs right through the main crossing between bedding and feeding puts your scent on their route every time you check a camera. Run it along the outside and let the lanes and plots reach in.

Trails also serve as firebreaks and as lines you can bush hog from. Lay the trail system out once, on a map, before we start, so it serves hunting, access and maintenance all at once.

Edge, bedding and the stuff you shouldn't clear

The best hunting tracts have a mix of mature timber, young thick cover, and openings. Don't mulch all the thick stuff — that's where deer bed. Instead, cut the edges to create more edge habitat, open a few small plots and lanes, and leave blocks of thicket between them. A tract that's uniformly open looks nice and holds fewer deer.

Along creeks, remember the state riparian buffer rules in the Jordan, Falls and Randleman Lake watersheds. Fifty feet from the stream is restricted. Creek bottoms are great hunting; just don't clear them. And keep the clearing away from property lines unless you want to advertise your plots to the neighbors.

Timber stand improvement and long-term habitat

If the tract is in loblolly pine, thinning and a controlled burn under NC Forest Service guidance turns a sterile pine stand into productive habitat with browse and cover. We can mulch the understory and cut firebreaks around burn units; the Forest Service or a consulting forester handles the burn planning. Hardwood tracts benefit from opening the canopy around mast-producing oaks.

Water is the other habitat piece. A small pond, a dug-out seep, or even a stock tank in a dry upland tract holds deer and turkeys through late summer. We dig small ponds and water holes with the excavator where the soil and the buffer rules allow, and a clay bottom in this area usually holds water without a liner.

The cost of hunting land prep is similar to any clearing job: mulching lanes and trails is the cheaper per-acre work, and full plot clearing with stump removal is the expensive part. Most ten-to-fifty-acre tracts get a lane and trail system plus two or three plots in a few days of machine time, with the soil work and planting on the landowner.

Related questions

When should I clear food plots for fall deer season?

July or early August at the latest. That leaves time to lime, work the soil and plant by mid-September. Start the conversation in spring.

Can I plant a food plot on a mulched area?

Not well. The root mat and chips stop a disc or drill. Plots need stumps removed and the ground worked. Lanes and trails can stay mulched.

How big should a food plot be?

Half an acre to two acres, irregular shape, in cover. Several small plots across a tract beat one big field.

Do you handle planting and lime?

We do the clearing, stump removal and rough grading. Lime, seed and planting are on the landowner or a local farmer with a drill. We'll leave the plot ready to work.

About the author. Clark Sellars owns and operates A&R Land Services in Greensboro, NC. He's a veteran and a working firefighter, and he runs the mulcher, the track loader and the excavator on every job the company takes.

Free on-site estimate. Straight answer.

Call, text, or send a few photos and the address. Clark walks the property with you and puts a real number on the work.

(336) 392-8138Request an estimate