A&R cuts trails through Alamance County woods without a pile of brush beside the path or a burn permit. The mulcher grinds the corridor to chips, the roots hold the clay, and your Graham trail is walkable before the trailer's hooked up.
Red clay climbs in Alamance County woods get slick under ATV tires. We put the climbs where the ground is firmest, angle them across the slope, and gravel the ones that are going to be wet regardless.



Graham ground conditions and how they shape trail cutting
The Iredell and Enon clays are the challenge — they rut, they slick, and they shrink and crack in a dry spell. We grade them only after a dry stretch and use track machines. The Graham-Mebane Lake watershed overlay limits impervious cover and puts buffers on Back Creek and its branches. Alamance County erosion control handles disturbance past an acre. Drainage is part of nearly every job here: swales, ditch cleaning and French drains to get standing water off the flat clay and moving.
Around Haw River, NC-87 and Graham-Mebane Lake, the properties we're usually called to look like this:
- Flat Iredell clay fields that need ditching and swales before they'll carry hay equipment
- Twenty- to eighty-acre cattle and hay farms off NC-87, NC-49 and Swepsonville Road reclaiming pasture from cedar and privet
- Fence-row and hedgerow clearing on old farms where the wire has disappeared into honeysuckle
What trail cutting jobs look like around Graham
Around Graham-Mebane Lake, the properties that call us for trail cutting tend to be flat Iredell clay fields that need ditching and swales before they'll carry hay equipment.
Closer to Graham-Hopedale Road it's more often uTV, ATV and dirt bike trails on recreational land — different layout, same machine, and the estimate reflects the difference honestly.
Graham isn't one kind of ground, and we don't price it like it is.
Neighbors in Snow Camp, Saxapahaw and Mebane call us for the same work; Graham sits right in the middle of that route.
Why Graham property owners call A&R
The owner cuts every Graham trail himself. Clark is a veteran and a working firefighter, and he's laid out enough routes through Alamance County woods to know where a trail will hold and where it'll wash.
Open up your Graham property. Reach out to A&R Land Services for trail and access path cutting anywhere in Alamance County.
Trail Cutting in Graham: questions
Will the trail turn into mud?
Not if it's routed right. A trail that runs straight down a slope on Piedmont clay becomes a gully; one that follows the contour and crosses slopes at an angle sheds water. We route for drainage, keep the mulch layer on the path, and put gravel on any stretch that's going to be wet no matter what — usually creek approaches and the bottom of climbs.
Do you remove the stumps on the trail?
Stumps inside the corridor get mulched to grade — low enough that they won't catch a tire, a hoof or a boot. On stretches where you want bare dirt for gravel we pull them with the excavator. Most trail customers are fine with mulched stumps and a chip floor.
How far is A&R Land Services from Graham?
We're based in Greensboro, about 30 minutes from Graham. Alamance County is inside the radius we work every week, so there's no long-haul mobilization charge built into your estimate.
Do you handle trail cutting near Haw River and NC-87?
Yes. We work throughout Graham and the surrounding Alamance County area, including properties around Haw River, NC-87 and Graham-Mebane Lake. If you're outside the town limits, send the address and we'll confirm it's in range.
What does trail cutting typically involve on a Graham property?
Equipment lanes to back fields, timber and ponds is the most common version of it around Graham. A written plan with the trail's length and width, where crossings are, any gravel or culvert work included, and the price. Trails are quoted by the job after the walk. Total trail length and width is the factor that moves the price most on Alamance County jobs, and we'll walk through it with you on site.